2026 SCM SCM CLASS S 520

Technical Data Useful working width mm. 520 Working surface size mm. 530x900 Working height min/max mm. 3.5/300 Maximum removal mm. 8 Minimum manufacturable length mm. 220 Minimum workable width mm. 10 Rotational speed of the shaft 4500 rpm. Shaft diameter mm. 120 N. 4 knives mm. 35x3x520 Feed speed 4-20 Inlet mouth diameter mm. 150 Standard equipment Motorized lifting of the platform at 2 speeds with micrometric feed Numeric reader of the working height with decimal control of the altitude Electronically driven variable drawbar speed via inverter from 4 to 20 m/min Vertical sliding worktable using 4 steel screws 1st incoming driven roller with helical grooved steel 2 (two) upper driving rollers in the outgoing covered with rubber Interchangeability of drive rolls Motor power 7kW 50Hz (8kW 60Hz) 7kW 9.5 HP 50Hz (8kW 11HP 60Hz) Manual star/delta motor starting (CE versions and with electrical protections) P.S. The machine must be electrically connected to the neutral as well Entrada e uscita pezzo Emergency button on the rear side of the machine (CE Version) Safety micro-switch on cuffione (CE Version) Lockable main switch Magnetothermal protection Auxiliary circuit transformer 110V Automatic motor brake (CE version) Optional accessories 53.03.07 Pneumatic adjustment of pressure on the upper draw rollers 32.03.07 Work table with 2 roller heads - N.B. Recommended solution for heavy carpentry operations where damp or resinous woods are processed 57.00.04 First upper feed roller coated in rubber as an alternative to the grooved steel roller 32.01.50 First drive roller segmented in steel as an alternative to the standard ribbed roller 57.02.41 Pulling rollers in stainless steel instead of those in rubber-coated steel N.B.: - The optional is recommended exclusively for work where there are no particular finishing requirements (e.g., heavy carpentry, packaging, drums for sofas). - It is recommended to pair with the thick plate option with nr. 2 idler rollers. 34.02.12 Monoblock tree with throwing knives of type "TERSA" Complete with a set of knives N.B. It is recommended to increase the power on the main motor in the presence of large material removals 57.03.23 "Xylent" spindle shaper spiral 3-series complete with cutting edge set: – no. 84 knives 15x15x2.5mm with 4 cutting edges and self-locking and self-centering screws – no. 1 torque wrench for correct and safe locking of the cutting edges – no. 2 inserts for the torque wrench 57.03.27 Xylent maintenance kit - Complete case including: – 1 bottle of detergent/degumming liquid for resin cleaning – 1 torque wrench calibrated to 5.7 Nm – 2 Torx T20 bits – 10 inserts 15x15x2.5 – 5 M6x15 T20 screws – 1 brass-bristle brush to clean the shaft with inserts – 1 steel-bristle brush to clean the insert seats 57.03.28 Kit 10 replacement inserts (15x15x2.5) for Xylent shaft 57.02.50 Extension to the plan at the outlet (dimensions 630 x 1200 mm) - Complete with automatic pneumatic locking Engine power 9kW 50Hz (11kW 60Hz) with automatic star-delta starting 9kW 12HP 50Hz (11kW 15HP 60Hz)