2026 SCM NOVA S520

TECHNICAL DATA Useful working width mm. 520 Working surface size mm. 530x900 Working height min/max mm. 3.5/300 Maximum removal mm. 8 Minimum workable length mm. 220 Minimum workable width mm. 10 Shaft rotation speed 4500 g/min. Shaft diameter mm. 120 N. 4 knives mm. 35x3x520 Feed rate 5-8-12-18 Inlet mouth diameter mm. 150 STANDARD EQUIPMENT Motorized lift of the table at 2 speeds with micrometric feed Readout of the working height with decimal control of the quota Vertical sliding working table by 4 steel screws 1st incoming feed roller in steel with helical groove Interchangeability of feed rollers Motor power 7kW 50Hz (8kW 60Hz) 7kW 9.5 HP 50Hz (8kW 11HP 60Hz) Manual star-delta motor start (CE versions and with electrical protections) Ingress and egress bands Piece front emergency pushbutton Piece rear emergency pushbutton (CE version) Micro switch at cuffion (CE version) Main switch padlockable Magnetic thermal protection Transformer for auxiliary circuit 110V Automatic motor brake (CE version) Optional accessories 57.01.38 Work table with 2 roller heads - N.B. Recommended solution for heavy carpentry operations where damp or resinous woods are processed 57.01.39 1st incoming feed drive roller segmented in steel as an alternative to the standard ribbed roller 57.00.73 Third motorized draw roll made of steel covered in rubber 57.02.36 Pulling rollers in stainless steel instead of those in rubber-coated steel N.B.: - The optional is recommended exclusively for operations where there are no particular finishing requirements (e.g., heavy carpentry, packaging, drums for sofas). - It is recommended to pair with the thickness plate option with no. 2 idler rollers. 57.01.40 Monobloc shaft with throwing knives of type "TERSA" Complete with a set of knives N.B. It is recommended to increase the power on the main motor in the presence of large material removals 57.03.23 "Xylent" spindle shaper spiral 3-series complete with cutting edges: – no. 84 knives 15x15x2.5mm with 4 cutting edges, with locknuts and self-centering screws – no. 1 torque wrench for correct and safe locking of edges – no. 2 inserts for the torque wrench 57.03.27 Xylent maintenance kit - Complete case including: – 1 bottle of detergent/degumming liquid for resin cleaning – 1 torque wrench calibrated to 5.7 Nm – 2 Torx T20 bits – 10 inserts 15x15x2.5 – 5 M6x15 T20 screws – 1 brass-bristle brush to clean the shaft with inserts – 1 steel-bristle brush to clean the insert seats 57.03.28 Kit 10 replacement inserts (15x15x2.5) for Xylent shaft 57.01.70 Motor power 9kW 50Hz (11kW 60Hz) with automatic star-delta starting 9kW 12HP 50Hz (11kW 15HP 60Hz)